TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 353 of 1008

TM 9-2350-261-20-2

REPLACE REAR MAIN WIRING HARNESS (M577A2 AND M1068 ONLY)

0287 00

THIS WORK PACKAGE COVERS:

Removal (page 0287 00-1).

Inspection and Repair (page 0287 00-16)

Installation (page 0287 00-16).

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

General Mechanic’s Tool Kit (WP 0780 00, Item 29)

Materials/Parts

Gasket

Grommet (12)

Lockwasher, as needed

N on

-

electrical wire, as need ed (WP 078 2 00, Item 40 )

Locknut (8)

Personnel Required

Unit Mechanic

Equipment Condition

Engine stopped/shutdown (see your -10)

Carrier blocked (see your -10)

Ramp lowered (see your -10)

FAX removed (TM 11-7010-256-12&P)

Access to batteries (see your -10)

Battery ground lead disconnected (WP 0294 00)

Rear floor plate removed (WP 0436 00)

REMOVAL

1.

Disconnect circuit 29 lead (1) from right fuel quantity sending unit (2).

2.

Remove lockwire (3), screw (4), lockwasher (5), and ground lead (6) from sending unit (2). Discard lockwire and

lockwasher.

3.

Remove three screws (7), two lockwashers (8), flat washer (9), ground lead (6), three clamps (10), and circuit 29 lead (1)

from three weldnuts (11). Discard lockwashers.

028700-1