TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 143 of 932

TM 9-2350-261-20-3

REPAIR DRIVER’S HATCH (M901A1 ONLY) — Continued

0449 00

16. Check that yoke support assembly linkage (1) is over center. If linkage is not over center, add shim laminations (2)

under bracket (3).

17. Push hatch release handle (4) up. Then measure between handle (4) and washer (5). Make sure gap is 0.06 (+0.03, -0.00)

inch. If clearance is not within limits, loosen or tighten nut (6), as required.

FOLLOW-THROUGH STEPS

1.

Start engine (see your -10).

2.

Raise and lock ramp (see your -10).

3.

Stop engine (see your -10).

END OF TASK

0449 00-19/20 blank