TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 549 of 932

TM 9-2350-261-20-3

REPLACE RAMP LOCK LEVER AND CABLE (M577A2 AND M1068 ONLY)

0562 00

THIS WORK PACKAGE COVERS:

Removal (page 0562 00-1).

Clean, Inspect, and Repair (page 0562 00-2).

Installation (page 0562 00-3).

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

General Mechanic’s Tool Kit (WP 0780 00, Item 29)

Materials/Parts

Cotter pin (2)

Key washer (4)

Locknut (4)

Locknut (2)

Lockwasher

Spring pin (2)

Personnel Required

Unit Mechanic

References

WP 0561 00

Equipment Condition

Engine stopped (see your -10)

Carrier blocked (see your -10)

Ramp lowered (see your -10)

REMOVAL

1.

Remove two cotter pins (1), headed pins (2), and clevises (3) from arms (4) and (5). Discard cotter pins.

2.

Remove two locknuts (6), washers (7), and screws (8) from lever (9). Discard locknuts.

3.

Bend back tabs on key washers. Remove four screws (10), key washers (11), and lever assembly (9) from hull top

plate. Discard key washers.

4.

Remove front support (12), lever (9), key (13), and rear support (12) from arm (4). Remove arm from bulkhead.

5.

Remove two spring pins (14), catch (15), and spring (16) from lever (9). Discard spring pins.

6.

Loosen two locknuts (17). Remove two clevises (3) and locknuts (17) from two joints (18). Discard locknuts.

056200-1