TM-9-2350-261-34
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2350-261-34 - Page 114 of 785
TM 9-2350-261-34
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS),
INCLUDING LUBRICATION INSTRUCTIONS
0014 00
THIS WORK PACKAGE COVERS:
General M aintenance Instructions (
page 0014 00-1
).
Preventive M aintenances Checks a nd Serv ices Including Lub rication I nstruction s (
page 0014 00-14
).
INITIAL SETUP:
Maintenance Level
Direct Support
Materials/Parts
Crocus cloth (WP 0105 00, Item 9)
Detergent (WP 0105 00, Item 12)
Solvent, cleaning compound (WP 0105 00, Item 10)
Wiping rag (WP 0105 00, Item 28)
References
See your -10
See your -20
TM 9-214
TM 9-2350-261-24P
TC 9-237
TM 43-0139
GENERAL MAINTENANCE INSTRUCTIONS
Scope
This section contains safety warnings, guidelines, and general maintenance instructions. They should be followed when doing
maintenance procedures authorized for direct and general support maintenance levels.
Preparation for Maintenance
1.
PERSONNEL SAFETY.
Practice all shop safety procedures and read all warnings in this manual.
2.
PROPER EQUIPMENT.
Get tools and equipment before starting a maintenance task. See TM 9-2350-261-24P and the
maintenance tasks for tools, equipment, parts, and materials.
3.
WHAT TO DISCARD.
Parts to discard, such as lockwashers, locknuts, and gaskets are listed in the maintenance tasks.
If the step does not say to discard a part, the part should be saved. It may be used later, or repaired.
4.
HANDLING TECHNIQUES.
a.
Avoid damage to parts during disassembly, cleaning, inspection, repair, and reassembly procedures. Nicks,
scratches, and dents caused by careless handling could result in equipment failure.
b.
Dirt can damage parts and cause malfunctions. Make sure all air and fluid openings, lines, and hoses are capped or
plugged during maintenance procedures.
5.
IDENTIFICATION.
a.
During disassembly, tag parts to ensure proper assembly.
b.
During disassembly, tag leads on electrical parts to ensure proper assembly. Tag each lead, as it is removed, with
numbers from wiring diagrams and terminals.
001400-1
Back to Top
