TM-9-2350-273-BD
M48/M60 SERIES TANK, COMBAT FULL-TRACKED 105-MM GUN
TECHNICAL MANUAL; OPERATORS, ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; BATTLEFIELD DAMAGE ASSESSMENT AND REPAIR
TM-9-2350-273-BD - Page 97 of 288
TM 9-2350- 273-BD
POWERTRAIN/STEERING
Procedural Steps (Cont’d)
3. Remove cap frorn converter control
valve located on side of valve body.
4. Pull out piston and spring inside valve body.
5. Remove the spring but leave existing
washers on piston.
6. Install the two washers, removed from
hydraulic power pack, on top of the existing washers.
7. Re-install spring on piston and place the large diameter end of piston in the cap.
8. Insert the piston and cap into the valve body and re-tighten the cap.
9. Record the BDAR action taken. When the [mission is completed, as soon as
practicable, repair tank using standard maintenance procedures.
7-4
Back to Top
