TM-9-2350-277-20-2

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 2 OF 6

TM-9-2350-277-20-2 - Page 482 of 783

TM 9-2350-277-20-2

ADJUST THROTTLE VALVE (TV) MODULATOR — Continued

0213 00

1.

Check to make sure throttle valve modulator lever (1) is in idle position.

2.

Adjust two hex nuts (2) so cable modulator bracket (3) is located near mid-range of threaded portion of cable housing

(4). Tighten nuts.

NOTE

Steps 3 - 15 are an initial adjustment prior to FIELD OPERATIONAL TEST.

3.

Check to make sure anchor (5) is 4-7/16 to 4-9/16 inches (11.3 to 11.5 cm) from bracket (3). If adjustment is needed,

loosen hex nut (6) and reposition lever (1) by adjusting two nuts (7) and (8) so anchor (5) is located near mid-range of

threaded portion of cable end (9). Tighten nuts (6), (7), and (8).

0213 00-2

Change 5