TM-9-2350-277-20-2

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 2 OF 6

TM-9-2350-277-20-2 - Page 486 of 783

TM 9-2350-277-20-2

ADJUST THROTTLE VALVE (TV) MODULATOR — Continued

0213 00

NOTE

If shifts are within ranges, adjustment is complete. If not, do Step 2 and Step 3.

2.

Iftheupshift1to2isbelow7mph(11km/h)

,doADJUSTStep11again.

3.

If upshift 2 to 3 is above 18 mph (29 km/h), do ADJUST Step 12 again.

NOTE

Do Step 4 only if the minimum/maximum shift points in Step 1 have not been obtained.

4.

If more adjustment is needed, reposition throttle valve modulator lever (1) as follows:

a.

Loosen hex nuts (2), (3), and (4).

b.

Adjust lever (1) away from modulator bracket (5) if upshift 1 to 2 is below 7 mph (11 km/h).

c.

Adjust lever (1) toward modulator bracket (5) if upshift 2 to 3 is above 18 mph (29 km/h).

d.

Tighten hex nuts (2), (3), and (4).

5.

Repeat Steps 1 - 4 until shift ranges are met.

FOLLOW-THROUGH STEPS

1.

Install driver’s power plant access panel (WP 0441 00).

2.

Close power plant access door. See TM 9-2350-277-10.

END OF TASK

0213 00-6

Change 5