TM-9-2350-277-20-2
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 2 OF 6
TM-9-2350-277-20-2 - Page 501 of 783
TM 9-2350-277-20-2
REPLACE UPPER ACCELERATOR PEDAL ASSEMBLY — Continued
0216 00
4.
Secure pedal guide (1) to bulkhead with four washers (2) and screws (3).
5.
Install link (4) on lower accelerator pedal (5) and secure with pin (6), washer (7) and new cotter pin (8).
6.
Install screw (9), washer (10) and new locknut (11) on new throttle control arm (12). Do not tighten at this time.
7.
Install hand throttle pin (13) with cable (14) on throttle control arm (12) and secure with washer (15) and new cotter
pin (16).
8.
Installdraglink(17)onthrottlecontrolarm(12)andsecure with screw (18), two washers (19) and new locknut (20).
9.
Install throttle control arm (12) on shaft (21). Align arm with woodruff key. Hold nut (11) and tighten screw (9).
10. Install drag link (17) on fuel control shaft plate (22) and secure with screw (23), washer (24) and new locknut (25).
021600-5
Change 5
Back to Top
