TM-9-2350-277-20-3

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 3 OF 6

TM-9-2350-277-20-3 - Page 493 of 941

TM 9-2350-277-20-3

NOTE

The M58 does not use connector, bushing, and hardware only adhesive sealant on wiring

harness in hull opening. To remove leads on M58, carefully cut adhesive sealant and pull

harness into carrier.

32. Loosen nut (14) that secures circuit 21 (15), 22 (16), 24 (17), and 30 (18) leads with rubber bushing (19) in connector

(20). Separate nut (14), washer (21), and rubber bushing (19) from connector.

33. Remove connector (20) and harness from top of hull. Pull harness into carrier.

34.

Remove 12 screws (1), washers (2), clamps (3), and harness (4) from left side plate of hull.

0362 00-14

Change 2

0362 00

REPLACE REAR MAIN WIRING HARNESS (M113A3,

M1059A3, AND

M58) — Continued