TM-9-2350-277-20-3

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 3 OF 6

TM-9-2350-277-20-3 - Page 718 of 941

TM 9-2350-277-20-3

REPLACE TOW START CONTROL ASSEMBLY AND BEARING — Continued

0391 00

INSTALLATION

1.

Route cable assembly (12) from driver’s compartment through mounting hole in bulkhead.

2.

Install jam nut (10) and washer (11) on threaded conduit end of control cable assembly (12). Tighten jam nut.

3.

Install cable bracket (6) and bearing (9) on top of transmission. Secure with two screws (7) and washers (8). TIGHTEN

SCREWS TO 18-20 LB-FT (24-27 N·m) TORQUE.

4.

Place two cable straps (1) on conduit end of cable assembly (5). Install cable straps with cable assembly on bracket (6).

Secure with two screws (2), washers (3), and new locknuts (4).

039100-5

Change 5