TM-9-2350-277-20-3

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 3 OF 6

TM-9-2350-277-20-3 - Page 719 of 941

TM 9-2350-277-20-3

REPLACE TOW START CONTROL ASSEMBLY AND BEARING — Continued

0391 00

5.

Install control lever (1) into bearing (2). Secure with clevis pin (3), two washers (4), and new cotter pin (5).

6.

Install clevis pin (6) on control lever (1). Secure with two washers (7) and new cotter pin (8).

7.

Install rear collar (9) with rear setscrew (10) onto cable end of cable assembly (11). Insert end of cable through mounting

hole on clevis pin (6). Install front collar (12) with front setscrew (13) on cable assembly.

8.

Push control handle to full in position. Move lever (1) until contact is made with surface of tow start button (14). Adjust

tow start button (14).

9.

Tighten setscrews (10) and (13).

WARNING

Sharp wire end can injure hands. Make sure wire is doubled over as a safety measure.

10

. Doublewire(15)overitself1/4inch(6mm)minimum,asshown.

0391 00-6

Change 5