TM-9-2350-277-20-4
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 4 OF 6
TM-9-2350-277-20-4 - Page 76 of 861
TM 9-2350-277-20-4
REPLACE T150 TRACK — Continued
0422 01
2.
Remove non-mating end connectors (2) from each track shoe assembly (1).
NOTE
Lift one side of track to get the correct angle of the track so the end connector will fit on both
track shoe pins. Keep shoes at the proper angle until end connector is installed flush against
track shoe.
3.
Position track shoe assemblies (1) so that connecting track shoes are approximately 2 inches off the ground (about
10 angle).
4.
Connect track shoe assemblies (1).
a.
Install two track pin alignment tools (4) over track shoe pins (5).
b.
Install two end connnectors (2) on track shoe pins (5). Remove track pin alignment tool (4) before driving end
connectors flush with pin ends.
c.
Drive end connectors (2) flush with pin ends and install bolts (3) on each end connector.
5.
Repeat Step 4 until a complete track has been connected in a line.
6.
Unblock vehicle (see your -10).
7.
(H): Drive vehicle backward until track (2) positions on sprockets (3).
8.
(H): Drive vehicle backward until track (2) is over idler wheels (1).
042201-3
Change 4
Back to Top
