TM-9-2350-277-20-4
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 4 OF 6
TM-9-2350-277-20-4 - Page 81 of 861
TM 9-2350-277-20-4
REPLACE T150 TRACK SHOE ASSEMBLY — Continued
0423 01
INSTALLATION
NOTE
Position track shoes at a slight angle to mount end connectors on both pins.
1.
Install track shoe (1) on track. Have helper assist.
a.
Install two track pin alignment tools (4) over track shoe pins (5).
b.
Install four end connectors (2) on track shoe pins (5). Remove track pin alignment tool (4) before driving end
connectors flush with pin ends.
c.
Drive end connectors (2) flush with pin ends and install bolts (3) on each end connector.
2.
Join track (see your -10).
3.
TIGH TEN F OU R BOLTS (3)
TO 4 00-430 LB-FT (543-583 N·M) TOR QUE.
FOLLOW-THROUGH STEPS
1.
Adjust track tension (see your -10).
2.
Unblock vehicle (see your -10).
3.
Road test vehicle to check that track is installed right (see your -10).
END OF TASK
0423 01-2
Change 4
4.
All new installed T150 track shoes require re-torquing between 30 and 80 miles of operation. END CONNECTOR
BOLTS NEED TO BE RE-TORQUED TO 400-430 LB-FT (543-583 N·M) TORQUE.
Back to Top
