TM-9-2350-277-20-5
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 5 OF 6
TM-9-2350-277-20-5 - Page 724 of 1047
TM 9-2350-277-20-5
REPLACE M13 NBC HEATER HOSES (M1068A3 ONLY) — Continued
0790 00
20. If grommet (1) was removed, install new grommet on driver’s inlet hose (2). Route hose through welded frame and
insert grommet in frame.
21. Install driver’s inlet hose (2) and two clamps (3) on manifold (4) and driver’s heater (5). Tighten clamps.
22. Install clamp (6) on driver’s inlet hose (2) and commander’s inlet hose (7). Secure clamp on sponson with screw (8)
and new lockwasher (9).
23. Install clamp (10) on driver’s inlet hose (2) and commander’s inlet hose (7). Secure clamp on welded bracket with screw
(11), two washers (12), and new locknut (13).
24. If bracket (14) was removed, install bracket on driver’s bulkhead with two screws (15), washers (20), and new
lockwashers (16).
25. Install driver’s outlet hose (17) and clamp (18) on connector (19) and driver’s heater (5). Tighten clamp.
FOLLOW-THROUGH STEPS
1.
Connect battery ground lead (WP 0338 00).
2.
Start engine (see your -10).
3.
Raise and lock ramp (see your -10).
4.
Stop engine (see your -10).
5.
Check air flow of NBC systems. Follow procedures in TM 3-6680-316-10.
END OF TASK
0790 00-9/10 blank
Change 4
Back to Top
