TM-9-2350-311-20-1
HOWITZER, MEDIUM, SELF-PROPELLED, 155MM; M109A2, M109A3, M109A4 AND M109A5
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL FOR HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS
AUGUST 1994
TM-9-2350-311-20-1 - Page 64 of 1275
TM 9-2350-311-20-1
2-13 WIRING HARNESS AND CABLE REPAIRS — CONTINUED
2-13.5 Typical Male-Type Panel Mounting Receptacle with Ridged Locking Nut — Continued
2-13.5.2 Assembly
a.
b.
c.
d.
e.
f.
g.
h.
Strip cable insulation equal to depth of solder wells of pin contacts.
Slide nut onto cable.
Slide grommet over cable leads.
Insert cable leads into solder wells of pin contacts and solder using resin core solder.
Push insert into shell from rear until seated. Groove in insert must be alined with guide in shell to ensure proper
fit.
Push pin contacts into insert from rear until seated.
Push grommet down cable leads and over solder wells of pin contacts.
Screw nut onto shell assembly.
2-13.6 Typical Female-Type Plug with Ridged Locking Nut
2-13.6.1 Disassembly
a. Unscrew nut from shell assembly and slide back on cable.
b. Slide grommet back on cable leads.
c. Slide coupling nut off shell.
d. Drive socket contacts out through rear of insert with pin extractor.
e. Push insert out through rear of shell.
f.
Unsolder leads from socket contact.
2-13.6.2 Assembly
2-16
Back to Top
