TM-9-2350-311-20-1
HOWITZER, MEDIUM, SELF-PROPELLED, 155MM; M109A2, M109A3, M109A4 AND M109A5
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL FOR HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS
AUGUST 1994
TM-9-2350-311-20-1 - Page 850 of 1275
TM9-2350-311-20-1
a.
b.
c.
d.
Removal
1 Disconnect connector (4) on inside of driver’s compartment.
2 Remove four nuts (5), four Iockwashers (6), four flat washers (7), Iockwasher (8), and four screws (9), and
disconnect connector (1) from driver’s bulkhead. Discard Iockwashers.
3 If replacement is necessary, remove four nuts (10), four Iockwashers (11), four washers (12), four screws (13),
gasket (14), and cover (15). Remove nut (16) and bolt (17) and disconnect positive lead (2) from battery
terminal. Discard Iockwashers and gasket.
4 Remove nut (18) and bolt (19) and disconnect ground lead (3) from battery terminal.
Disassembly
Disassemble lead assembly (para 2-13).
Assembly
Assemble lead assembly (para 2-13).
Installation
1 Connect ground lead (3) to battery terminal with bolt (19) and nut (18).
2 If replaced, connect positive lead (2) to battery terminal and install bolt (17) and nut (16). Install new gasket
(14), cover (15), four screws (13), four washers (12), four new Iockwashers (11), and four nuts (10).
3 Connect connector (1) to driver’s bulkhead and install new Iockwasher (8), four screws (9), four flat washers
(7), four new Iockwashers (6), and four nuts (5).
4 Connect connector (4) on inside of driver's compartment.
FOLLOW-ON MAINTENANCE:
NOTE
Connect batteries (para 8-28)
8-205
Back to Top
