TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 320 of 508

TM 9--2520--215--34

0062 00--6

TORQUE CONVERTER HOUSING ASSEMBLY REPAIR – CONTINUED

0062 00

ASSEMBLY – Continued

2. Install ball bearing (10) in gears (9), if removed. Support gears (9), front side down.

9

10

3. Stake edges of gear hubs over bearings (10) at four points on each gear. Place a 1/4--inch steel ball on the hub

close to bore of gear (9). Strike with hammer. Bearing (10) must rotate freely after striking.

NOTE

Assure that bent tabs on lockplates align with milled flats on lockplate mounting bosses.

4. Start two spindles (8) into front side of gears (9). Position gears (9) and spindles (8) in converter housing (5).

Align tapped holes in spindles (8) with holes in lockplates (7).

5

9

8

7