TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 438 of 508

TM 9--2520--215--34

0078 00--10

TRANSMISSION HOUSING ASSEMBLY AND STEERING COMPONENTS

REPLACEMENT – CONTINUED

0078 00

INSTALLATION – Continued

NOTE

Bearing used in right side of flywheel must have bronze separator.

5. Remove two bolts (22) temporarily installed in Installation Step 4. Install six lock strips (21) and 12 bolts (22).

Tighten 12 bolts (22) to 96 to 115 lb--ft (130.2 to 155.9 N

S

m). Bend corners of each lock strip (21) against heads

of 12 bolts (22). Install bearing spacer (27) and bearing assembly (26), tapping bearing assembly (26) lightly into

bore of flywheel (24).

6. Install spacer (35). Install new internal snap ring (38) into inner groove and install bearing (39) against new snap

ring (38).