TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 269 of 319

TM 9-2520-238-34

REPAIR STEERING CONTROL DIFFERENTIAL HOUSING — Continued

0029 00

5.

Clean threads of lifting eye (1). Apply a light coat of antiseize compound to threads.

6.

Install lifting eye (1) in housing (2) by turning lifting eye to the right.

NOTE

If resilient mounts were removed in page 0029 00-2, do Step 7.

7.

Install resilient mounts (3). Use remover and replacer.

8.

Install new grommet (4) in strainer (5).

9.

Place two retainers (6) in housing (2).

10. Place strainer (5) in housing (2). Secure to two retainers (6) with eight washers (7) and cap screws (8). Install new

lockwire (9) between screws on each retainer.

11. Install two new needle roller bearings (10) on right side housing (2).

12. Install two new needle roller bearings (10) on left side housing (2).

NOTE

If any alignment dowel pins were removed from housing in page 0029 00-2, do Step 13 and Step

14.

13. Install new alignment dowel pin (11) to protrude 21/32 inch (1.68 cm) from housing (2).

14. Install two new alignment dowel pins (12) to protrude 3/8 inch (.97 cm) from housing (2).

WEAR LIMITS

1.

See TM 9-214 to check bearings.

0029 00-5