TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 276 of 319

TM 9-2520-238-34

REPAIR SINGLE DISK PIVOT STEER BRAKE ASSEMBLY — Continued

0030 00

NOTE

On some early brake assemblies, the lining is held in place with two rivets and two clips.

Remove and discard rivets, if installed.

4.

Remove retaining ring (3), spacer (4), and packing (5) from release unit nut (6). Discard retaining ring and packing.

5.

Repeat Steps 1 - 4 above for other housing.

NOTE

If vehicle has optional pivot steer brake, do Steps 6 - 9.

6.

Remove shoulder screw (7) from brake housing (8). Remove packing (9) from screw. Discard packing.

7.

Remove release unit piston (10) with attached brake lining (11) from housing (8) using an arbor press. Remove packing

(12) from piston. Discard packing.

8.

Remove release unit nut (13) from housing (8) using remover and replacer tool. Remove packing (14) from release unit

nut. Discard packing.

NOTE

Turn remover and replacer tool in the clockwise direction.

9.

Separate brake lining (11) from piston (10) using brake and clutch reliner.

0030 00-4