TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34

  TM-9-2520-238-34 - Page 279 of 319

TM 9-2520-238-34
REPAIR SINGLE DISK PIVOT STEER BRAKE ASSEMBLY — Continued
0030 00
7.
Lubricate new packing (4) with grease or petrolatum, and install packing, spacer (5), and new retaining ring (6) in release
unit nut (7).
8.
Lubricate new packing (8) with grease or petrolatum, and install new packing (8) on release unit nut (7).
9.
Install release unit nut (7) in brake housing (9) using remover and replacer tool.
NOTE
Turn remover and replacer tool in the counterclockwise direction.
10. Deform one thread in release unit nut (7) securely in two places a minimum of 45 degrees from holes in unit.
11. Lubricate new packing (10) with grease or petrolatum, and install packing on release unit piston (3).
12. Place brake lining (11) on face of release unit piston (3). Using brake and clutch reliner, install piston with lining in
housing (9) until piston is flush with outer edge of release unit nut (7).
END OF TASK
0030 00-7/8 blank


Back to Top