TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 392 of 933

TM 9-2520-270-34

14. REMOVE BEARING (1) FROM GEAR (2).

a. Set up gear (2) in arbor press on two

blocks of wood.

b. Using bearing installer (3), press out

bearing (1).

I

15. INSPECT BUSHING (4).

a. Inspect bushing (4) for grooves, scoring,

and scratches.

b. If bushing (4) is damaged, go to step 16.

If not, go to step 17.1.

16. IF GEAR

(2) WAS NOT REMOVED, GO TO

STEP 17. IF GEAR WAS REMOVED, GO TO

STEP 17.1

17. REPAIRER AND HELPER REMOVE

GEAR (2) FROM HOUSING (5).

a. (H) Hold housing (5) on workbench.

b. Remove Iockwire (6) from six

screws (7).

c. Remove six screws (7) and

washers (8). Turn over housing (5).

d. Using pry bar, evenly pry off gear (2).

4-86

Change 3