TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 395 of 933

21. IF GEAR (1) WAS REMOVED, HEAT GEAR

TO 200° F (93° C) IN OVEN FOR

30 MINUTES. IF NOT, GO TO STEP 30.

22. USING GLOVES, REMOVE

GEAR (1) FROM OVEN AND

PLACE HOUSING (2) ON GEAR.

24. PRESS GEAR (1) ONTO HOUSING (2).

a.

b.

c.

Set up housing (2) in arbor press on

two wood blocks.

Using arbor press, press on gear (1).

Let parts cool to room temperature.

23. POSITION GEAR (1).

a. Aline screw holes of gear (1) and

housing (2).

b. Install three washers (3) and screws (4)

in every other mounting hole to aline

gear (1). Do not tighten.

25. REMOVE THREE SCREWS (4) AND

WASHERS (3).

GO TO NEXT PAGE

Change

3

4-87

TM 9-2520-270-34

WARNING

Do not handle hot or cold parts

without protective gloves.

Personnel can be injured.