TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 402 of 933

TM 9-2520-270-34

17. POSITION TRANSMISSION (1) SUMP

SIDE UP.

CAUTION

Do not use metal prybar to loosen input bevel

assembly. Damage to equipment can occur.

18.

LOOSEN INPUT BEVEL ASSEMBLY

(2).

a. Remove eight screws

(3)

and

washers

(4).

b. Place wood dowel

(5)

between gear

shaft

(6)

and input bevel assembly

(2)

c. Pry input bevel assembly

(2)

forward

one inch.

d. Remove wood dowel

(5).

WARNING

Input bevel assembly is heavy

and awkward. Remove slowly

or input bevel assembly can

fall and injure you.

Shims have sharp edges and

can cut hands. Use leather

gloves when removing input

bevel assembly and shims.

18.1

REMOVE INPUT BEVEL ASSEMBLY (2).

a. Using both hands with leather gloves,

grasp assembly (2) and pull straight out.

b. Retain shims (7) with assembly (2).

4-96

Change 3