TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 408 of 933

TM 9-2520-270-34

34. REMOVE SPIRAL BEVEL PINION (1)

WITH CONE AND ROLLERS (2) FROM

GEARSHAFT (3).

a. Using mechanical puller kit, remove

pinion (1) with cone and rollers (2)

from gearshaft (3).

37. CHECK PINION (1)

a.

b.

4-100

Using micrometer caliper set, measure

outside diameter of pinion (1).

Replace pinion (1) if measurement is

less than 3.6265 inches (92.1 113 mm).

35. REMOVE CONE AND ROLLERS (2)

FROM PINION (1).

a. Using mechanical puller kit, remove

cone and rollers (2) from pinion (1).

Discard cone and rollers.

36. INSPECT PINION

a. Inspect pinion

I

page 2-5,

(1).

(1) for damage, See

b. If pinion (1) is not damaged, go to

step 37. If pinion is damaged, replace

pinion and cone and rollers (2). Go

to step 38.

38. INSPECT ROLLER CUP (4).

a. Inspect cup (4) for damage.

TM 9-214.

b. If cup (4) is damaged, go to

If not, go to step 40.

See

step 39.