TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 414 of 933

TM 9-2520-270-34

NOTE

It is necessary to look through bottom of

transmission to see gear touch fixture.

58. POSITION INPUT BEVEL

ASSEMBLY (1) INTO HOUSING (2).

a. Coat outside of assembly (1) with

transmission oil.

b. Using plastic-faced hammer, tap

assembly (1) into housing (2) until

contact with fixture (3) is made.

c. Do not allow screw holes (4) to

aline with holes in housing (2).

59. MEASURE DISTANCE FROM

WASHERS (5) TO HOUSING (2).

a.

b.

c.

Place same two washers (5) on same

spot faces (6) marked in step 55.

Using depth gage, measure distance

from washers (5) to housing (2) through

screw hole (7) of mounting flange (8).

Repeat step 59b for three other spot

faces (6).

4-106

60. OBTAIN DIMENSION C.

a. Add four distances.

b. Divide result of step 60a by four.

c. Record result as dimension C.

WARNING

Input bevel assembly is

heavy and awkward.

Install

slowly or input bevel

assembly can fall and

injure personnel.

CAUTION

Use care when pushing input bevel assembly

into transmission housing. Equipment can be

damaged.