TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 418 of 933

TM 9-2520-270-34

WARNING

Input bevel assembly is heavy

and awkward. Remove slowly

or input bevel assembly can

fall and injure you.

75. REMOVE INPUT BEVEL ASSEMBLY (1).

a.

b.

c.

Remove eight screws (2) and

washers (3).

Using both hands, grasp assembly (1)

and pull straight out.

Remove and save shim(s) (4) for

step 84.

NOTE

Shim(s) will only goon one way. Nicks and burrs

must be removed from shim(s) before use.

77. INSTALL LEFT SIDE SET RETAINER (6)

AND SHIM(S) (7),

a,

b,

c.

d.

e.

If shim(s) (7) were lost or damaged

during removal, start installation with

.050 inch shim(s).

Remove tags from retainer (6) and

shim(s) (7).

Aline six bolt holes in retainer (6) and

shim(s) (7) with holes in housing (8).

Using plastic-faced hammer, tap

retainer (6) into housing (8).

Install six bolts (9).

78. USING l/2-l NCH DRIVE TORQUE

WRENCH, TORQUE SIX BOLTS (9)

TO 25-30 ft-lb (3-4 mkg).

4-110

NOTE

Fixture must be pulled part way out and tilted

to remove. Fixture is exact fit and can easily

stick.

76. REMOVE FIXTURE (5).