TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 425 of 933

TM 9-2520-270-34

110. REPLACE SHIM(S) (1) WITH SET THAT

IS 0.005 INCH (0.13 mm) THINNER.

114. REMOVE TWO SCREWS (5)

AND CLUTCH HOUSING (6).

a. Working on right side of trans-

mission, remove two screws (5) and

clutch housing (6).

NOTE

Nicks and burrs must be removed from shim(s)

before use.

111. INSTALL RETAINER (2) AND

SHIM(S) (1).

a.

b.

c.

Working on right side of transmission,

slide shim(s) (1) onto retainer (2) and

press retainer into housing (3).

Aline six bolt holes in retainer (2) and

shim(s) (1) with housing (3). Using

plastic-faced hammer, tap retainer (2)

into place.

Install six bolts (4).

112. USING l/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX BOLTS (4)

TO 25-30 ft-lb (3-4 mkg).

113. ROTATE TRANSMISSION SO BOTTOM

SIDE IS UP AND GO TO STEP 88.

GO TO NEXT PAGE

4-117