TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 423 of 933

TM 9-2520-270-34

101. REPLACE SHIM(S) (1) WITH SET THAT

IS 0.005 INCH (0.13 mm) THINNER.

GO TO STEP 103.

102. REPLACE SHIM(S) (1) WITH SET THAT

IS 0.005 INCH (0.13 mm) THICKER.

NOTE

Nicks and burrs must be removed from shim(s)

before use.

103. INSTALL RETAINER (2) AND

SHIM(S) (1).

a. Slide shim(s) (1) onto retainer (2)

and press retainer into housing (3).

b. Aline six bolt holes in retainer (2)

and shim(s) (1) with housing (3).

Using plastic-faced hammer, tap

retainer (2) into place.

c. Install six bolts (4).

104. USING l/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX BOLTS (4)

TO 25-30 ft-lb (3-4 mkg).

GO TO NEXT PAGE

4-115