TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 413 of 933

TM 9-2520-270-34

55. MEASURE THICKNESS OF MOUNTING

FLANGE (1) AND WASHERS (2).

a. Place two washers (2) from step 17 on

spot face (3).

b. Using micrometer caliper set, meas-

ure thickness of flange (1) and two

washers (2) together in four places.

c. Put temporary mark (4) on flange (1)

at four spot faces (3).

d. Retain washers (2).

NOTE

Fixture cannot be placed straight into housing.

It must be tilted at an angle so that flange

end of fixture fits through slot in gear shaft

housing hole. Fixture is exact fitting and

can easily stick.

57. INSTALL BEVEL GEAR SHIMMING

FIXTURE (5) THROUGH LEFT SIDE

OF TRANSMISSION (6).

a. Seat fixture (5) in transmission (6).

56. OBTAIN DIMENSION B.

a. Add four thicknesses.

b. Divide result of step 56a by four.

c. Record result as dimension B.

GO TO NEXT PAGE

4-105