TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 421 of 933

TM 9-2520-270-34

89 ALINE PAINTED TOOTH (1) ON

INPUT BEVEL ASSEMBLY (2) WITH

TWO PAINTED TEETH (3) ON

PINION (4).

91. INSTALL THIRD RANGE CLUTC H

a.

Looking into bottom of transmission,

HOUSING (6).

rotate input shaft (5) until tooth (1)

is between two teeth (3).

90. ROTATE TRANSMISSION SO TOP SIDE

IS UP.

CAUTION

Do not use excessive force when tightening

clamp. Damage to equipment can occur.

92. LOCK CLUTCH HOUSING (6) TO

TRANSMISSION HOUSING (9).

a.

b.

Working on right side of transmission,

lock clutch housing (6) to transmission

housing (9). Use C-clamp.

Tighten clamp only enough to prevent

clutch housing (6) from rotating.

a. Working on right side of transmission,

position and hold housing (6) on

gearshaft (7).

b. Install two screws (8).

93. ATTACH ANGLE BRACKET (10)

AND BACKLASH ACTUATOR (11).

a. Fasten bracket (10) to housing (9)

using two Power Takeoff Assembly

mounting screws (12).

b. Position actuator (11) on input

gearshaft (5).

GO TO NEXT PAGE

4-113