TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 427 of 933

TM 9-2520-270-34

120. REPLACE SHIM(S) (1) WITH SET THAT

IS 0.005 INCH (0.13 mm) THINNER.

124. REMOVE BRACKET (5).

a. Remove two screws (6) and

bracket (5). Place screws with power

takeoff assembly for reinstallation.

Nicks and burrs must be removed from shim(s)

before use.

121. INSTALL RIGHT SIDE SET

RETAINER (2) AND SHIM(S) (1).

a.

b.

c.

Slide shim(s) (1) onto retainer (2)

and press retainer into housing (3).

Aline six bolt holes in retainer (2)

and shim(s) (1) with housing (3).

Using plastic-faced hammer, tap

retainer into place.

Install six bolts (4).

122. USING l/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX BOLTS (4)

TO 25-30 ft-lb (3-4 mkg).

123. ROTATE TRANSMISSION SO BOTTOM

SIDE IS UP AND GO TO STEP 88.

125. WORKING ON RIGHT SIDE OF

TRANSMISSION, REMOVE SIX

BOLTS (4) FROM RETAINER (2).

126. COAT THREADS OF SIX BOLTS (4)

WITH SEALANT COMPOUND.

127. INSTALL SIX BOLTS (4)

IN RETAINER (2).

128. USING l/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX BOLTS (4)

TO 25-30 ft-lb (3-4 mkg).

GO TO NEXT PAGE

4-119

NOTE