TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 419 of 933

TM 9-2520-270-34

CAUTION

Use care when installing gearshaft or

damage to hose assembly and hose clamp

can result.

79. INSTALL GEARSHAFT (1) IN RIGHT

SIDE OF HOUSING (2).

NOTE

Shim(s) will only go on one way. Nicks and burrs

must be removed from shim(s) before use.

81. INSTALL RIGHT SIDE SET

RETAINER (4) AND SHIM(S) (5).

a.

b.

c.

d.

e.

If shim(s) (5) were lost or damaged

during removal, start installation with

.065 inch shim(s).

Remove tags from retainer (4) and

shim(s) (5).

Aline six bolt holes in retainer (4) and

shim(s) (5) with holes in housing (2).

Using plastic-faced hammer, tap

retainer (4) into housing (2).

Install six bolts (6).

82. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX BOLTS (6)

TO 25-30 ft-lb (3-4 mkg).

WARNING

Coupling can fall off shaft.

Personnel can be injured.

80. COAT INSIDE OF COUPLING (3)

WITH TRANSMISSION OIL. INSTALL

COUPLING ON GEARSHAFT (1).

GO TO NEXT PAGE

4-111

WARNIN G

Do not drop gearshaft.

Personel can be injured.