TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 424 of 933

TM 9-2520-270-34

105. REMOVE CLUTCH HOUSING (1).

a. Working on right side of transmission,

remove two screws (2) and clutch

housing (1).

NOTE

Thickness of each shim is marked on face of shim.

107, FIND TOTAL THICKNESS OF ALL

SHIM(S) (4).

108. IF BACKLASH IS GREATER THAN

0.011 inch (0.28 mm), GO TO

STEP 109. IF BACKLASH IS LESS

THAN 0.008 INCH (0.20 mm), GO

TO STEP 110.

106, REMOVE RETAINER(3) AND

SHIM(S) (4).

a.

b.

c.

Remove six bolts (5).

Using plastic-faced hammer, tap

spur gearshaft (6) from opposite

side of transmission to loosen

retainer (3).

Using pry bar behind shims (4), care-

fully remove retainer (3) and shim(s).

109. REPLACE SHIM(S) (4) WITH SET THAT

IS 0.005 INCH (0.13 mm) THICKER.

GO TO STEP 111.

4-116