TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 416 of 933

TM 9-2520-270-34

NOTE

Input bevel repair kit contains shims of several

thicknesses for making bearing housing shim.

Nicks and burrs must be removed from shim(s)

before use.

65.

66.

ROTATE TRANSMISSION SO BOTTOM

SIDE IS UP.

INSTALL INPUT BEVEL ASSEMBLY (1)

WITH NEW SHIM(S) (2) AS

DETERMINED IN STEP 63.

a. Slide shim(s) (2) onto assembly (1)

and aline screw holes and oil holes (3).

Shim(s) go on one way.

b. Coat assembly (1) with transmission

oil.

c. Push assembly (1) into housing (4)

until all holes are alined.

67.

68.

INSTALL EIGHT WASHERS (5) AND

SCREWS (6).

USING l/2-lNCH DRIVE TORQUE

WRENCH, TORQUE EIGHT SCREWS (6)

TO 25-30 ft-lb (3-4 mkg).

4-108

69. OBTAIN DIMENSION F.

a. Subtract 0.003 inch (.08 mm) from

dimension A.

b. Record result as dimension F.