TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 530 of 933

TM 9-2520-270-34

7. INSPECT THIRD RANGE CLUTCH

HOUSING (1) FOR DAMAGE.

a. Inspect clutch housing (1) for damage.

See page 2-5.

b. If clutch housing (1) is damaged, go

to step 8. If not, go to step 9.

9. IF CLUTCH HOUSING (1) WAS

REMOVED, GO TO STEP 10. IF

NOT, GO TO STEP 12.

10. INSTALL NEW CLUTCH HOUSING (1).

a. Hold clutch housing (1) on gearshaft

spline (3) and aline six screw holes.

b. Install six screws (2).

11. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE SIX SCREWS (2)

TO 10-12 ft-lb (1-2 mkg).

8. REMOVE CLUTCH HOUSING

a. Remove six screws (2).

b. Lift off clutch housing (1).

c. Replace clutch housing (1).

(1).

GO TO NEXT PAGE

4-209