TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 538 of 933
TM 9-2520-270-34
22. INSTALL RETAINING RING (1).
a. Place two “C” clamps (2) on clutch
assembly (3) opposite each other.
b. Tighten two “C” clamps (2) evenly until
retaining ring groove (4) can be seen.
c. Using retaining-ring pliers, install
retaining ring (1).
d. Remove two “C” clamps (2).
24. OBTAIN DIMENSlON A.
a.
b.
c.
Add three dimension obtained in
step 23a.
Divide results of step 24a by three.
Record results as dimension A.
23. CHECK CLEARANCE (5) IN FRICTION
CLUTCH ASSEMBLY (3).
a. Measure clearance between clutch
friction plate (6) and backup Plate (7) in
three places.
b. If clearance (5) is 0.055 to 0.075 inch
(1.40 to 1.90 mm), go to END OF TASK. If
not, go to step 24.
24.1 REMOVE RETAINING RING (1).
a.
b.
c.
Place two “C” clamps (2) on clutch
assembly (3) opposite each other.
Tighten two “C” clamps (2) evenly to
relieve pressure on retaining ring (1).
Using retaining-ring pliers, remove
retaining ring (1).
GO TO NEXT PAGE
Change 3
4-216.1 (4-216.2 blank)
Back to Top
