TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 545 of 933

TM 9-2520-270-34

8. DISCONNECT HOSE ASSEMBLY

NUT (1) FROM HOSE TO BOSS

ELBOW (2).

10. REMOVE FIVE SCREWS (8)

FROM HOUSING ASSEMBLY (4).

a. Remove five screws (8) and lock

washers (9). Discard lock washers.

11. REMOVE SCREW (10).

a. Remove screw (10) and lock

washer (11), Discard lock washer.

NOTE

Observe how the hose assembly is routed. It

must be put back the same way.

9. RELEASE HOSE ASSEMBLY (3) FROM

LEFT-HAND INTERMEDIATE HOUSING

ASSEMBLY (4).

a. Using wire-twister pliers, remove and

discard Iockwire (5) from two screws (6)

and clamps (7).

b. Using 3/8-inch drive ratchet handle

and 5/32-inch socket wrench attach-

ment, remove two screws (6) and

clamps (7). Discard screws.

12. REMOVE LIFTING EYE (12).

a. Remove two screws (13) and lock

washers (14). Discard lock washers.

b. Remove lifting eye (12).

4-222

Change 1