TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 546 of 933

TM 9-2520-270-34

13.

14.

15.

a. Use pry slot (5) to loosen housing

assembly (4).

INSTALL TWO EYEBOLTS (1) IN

TWO THREADED HOLES (2).

ATTACH AND SECURE LIFTING

DEVICE (3) TO TWO EYEBOLTS (1).

LOOSEN HOUSING ASSEMBLY (4).

CAUTION

Cross shaft must slide free when removing

housing assembly. Failure to do so can

cause damage to equipment.

16. PARTIALLY RAISE HOUSING

ASSEMBLY (4) TO FREE COMPONENTS.

a.

b.

c.

(H) Feed hose assembly (6) through

hole (7), Repairer lift housing

assembly (4) evenly 1/4 inch at a

time. Do not allow cross shaft (8)

to stick in spur gear (9).

Inspect that spur gear cluster (10)

is not stuck to housing assembly (4).

If spur gear cluster (10) is stuck

to housing (4), remove it and place

in positive clutch (11).

GO TO NEXT PAGE

4-223