TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 544 of 933

TM 9-2520-270-34

NOTE

Spur gear and bearing may have been removed.

Keep it with this housing.

3. REMOVE SPINDLE ASSEMBLY (1)

IF

a.

b.

c.

d.

INSTALLED.

Remove two screws (2), washers (3),

and sleeve spacers (4).

Rotate spindle cap (5) until it

partly covers screw hole (6).

Using screwdriver in screw holes (6),

pry up spindle cap (5).

Remove spindle assembly (1).

6. REMOVE RING (8).

a.

b.

Squeeze ring (8) with fingers until

hooks (9) release.

Spread open and remove ring (8).

Discard ring.

4. REMOVE AND DISCARD TWO

PREFORMED PACKINGS (7).

5. INSPECT METAL SEAL RING (8).

a. Inspect ring (8) for damage. See

page 2-5.

b. If ring (8) is damaged, go to step 6.

If not, go to step 7.

WARNING

Use care when removing

retaining ring. Retaining ring

can fly. Personnel can be

injured. Always wear goggles.

7. REMOVE RETAINING RING (10) AND

SHIM (11).

a. (H) Reach in through controller

opening (12) and pry up cross

shaft (13).

b. Using retaining-ring pliers, remove

retaining ring (10).

c. Remove shim (11).

GO TO NEXT PAGE

4-221