TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 541 of 933
TM 9-2520-270-34
28. DELETED.
29. SELECT NEW CLUTCH SEPARATOR
PLATE (1) FROM REPAIR KIT.
a.
b.
c.
If dimension A in step 24 is less than
0.041 inch (1.04 mm), replace separator
plate 11629076-3 with separator
plate 11629076-1 from repair kit.
If dimension A in step 24 is less than
0.055 inch (1.39 mm), replace separator
plate 11629076-3 with separator
plate 11629076-2 from repair kit.
If dimension A in step 24 is greater than
0.075 inch (1.90 mm), replace separator
plate 11629076-1 with separator
plate 11629076-2 from repair kit.
30.
31.
INSTALL TWO NEW SEPARATOR
PLATES (1) AND TWO FRICTION
PLATES (2).
a. Install two new separator plates (1) and
two friction plates (2) alternately,
starting with a separator plate.
GOT TO STEP 21.
END OF TASK
4-218
Change 3
Back to Top
