TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 549 of 933

TM 9-2520-270-34

28. INSPECT CLUTCH DISK (1) FOR

DAMAGE. See page 2-5.

a. If disk (1) is damaged, go to

step 30. If not, go to step 29.

NOTE

When Installing parts with splines or gear teeth,

make sure that mating parts mesh properly.

31. INSTALL SPUR GEAR (4) WITH

STRAIGHT SHAFT (5) AND THRUST

WASHER BEARING (6) IF REMOVED.

a. Install bearing (6). Two tabs on

bearing go into two holes (7) in

left-hand hydraulic assembly (8).

b. Install gear (4) with straight shaft (5).

Gear goes all the way into differential

carrier assembly (9).

29. CHECK CLEARANCE (2) OF

CLUTCH DISK (1).

a. Measure clearance (2) between clutch

disk (1) and four brake pads (3).

b. If clearance (2) is 0.021-0.060 inch

(0.53-1.52 mm), go to step 31. If not,

go to step 30.

30. REPLACE LEFT-HAND SINGLE

DISK BRAKE, page 4-255.

4-226