TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 557 of 933

TM 9-2520-270-34

WARNING

Use care when installing

retaining ring. Retaining ring

can fly. Personnel can be

injured. Always wear goggles.

65. INSTALL SHIM (1) AND RETAINING

RING (2).

a. (H) Reach in through controller

opening (3) and pry up cross

shaft (4).

b. Install shim (1).

c. Using retaining-ring pliers, install

retaining ring (2).

66. MEASURE GAP BETWEEN RETAINING

RING (2) AND SHIM (1).

a. (H) Pry up cross shaft (4) through

controller opening (3).

b. Measure gap between retaining

ring (2) and shim (1). Lower cross

shaft (4).

c. If gap is 0.028-0.037 inch

(0.71-0.94 mm), go to step 71. If

not, go to step 67.

4-234