TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 558 of 933
TM 9-2520-270-34
WARNING
Use care when removing
retaining ring. Retaining ring
can fly. Personnel can be
injured. Always wear goggles.
67. REMOVE RETAINING RING (1).
a. (H) Pry up cross shaft (2) through
controller opening (3).
b. Using retaining-ring pliers, remove
retaining ring (1).
68. SELECT NEW SHIM (4) FROM CROSS
SHAFT SHIM KIT.
a. Using micrometer caliper set, select
new shim (4) from shim kit that will give
a gap of 0.028-0.037 inch
(0.71-0.94 mm).
69. INSTALL NEW SHIM (4).
70. INSTALL RETAINING RING (1).
a. (H) Reach in through controller opening
(3) and pry up cross shaft (2).
b. Using retaining-ring pliers, install
retaining ring (1).
C
. Go to step 66.
71. INSTALL LEFT-HAND OUTPUT HOUSING.
See task REPLACE LEFT-HAND OUTPUT
HOUSING, page 4-314.
72. INSTALL CONTROLLER ASSEMBLY. See
task REPLACE CONTROLLER ASSEMBLY,
page 3-32.
END OF TASK
4-235
Back to Top
