TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 567 of 933

TM 9-2520-270-34

27. CHECK GEARSHAFT (1).

a. Using micrometer caliper set, meas-

ure outside diameters (2), and (3).

28. REPAIRER AND HELPER, TURN

HOUSING (4) OVER.

29. REMOVE SPUR GEAR (5).

b. Replace gearshaft (1) if either

a. Using screwdriver, remove

measurement is less than

interlocking retaining ring (6).

2.9524 inches, (74.991 mm).

b. Using pry bar, remove gear (5).

30. INSPECT BALL BEARING (7).

a. Inspect bearing (7) for damage.

See TM 9-214.

b. If bearing (7) is damaged, go to

step 31. If not, go to step 33.

31. REMOVE BEARING (7).

a. Using screwdriver, remove retaining

ring (8).

b. Using hammer and punch, remove and

discard bearing (7).

4-242