TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 574 of 933

TM 9-2520-270-34

65. INSTALL LUBE BLOCK (1).

a. Position new gasket (2) and lube

block (1),

b. Install two washers (3) and

screws (4).

66. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE TWO SCREWS (4)

TO 10-12 ft-lb (1-2 mkg).

CAUTION

Beveled side of end plate must be installed

toward housing. End plate must be installed

by hand. Damage to equipment can occur.

68. INSTALL GEAR (7).

a.

b.

Install end plate (8) with beveled

side (9) toward housing.

Install gear (7).

67. INSTALL ROLLER BEARING (5).

a. Using screwdriver, install retaining

ring (6) in gear (7).

b. Using arbor press and bearing

installer (Item 8), press

bearing (5) against ring (6).

c. Using screwdriver, install second

retaining ring (6).

CAUTION

Shaft shoulder must be installed by hand.

Damage to equipment can occur.

69. INSTALL SHAFT SHOULDER (10).

a. Install shaft shoulder (10).

b. Using retaining-ring pliers (Item 59),

install retaining ring (11).

GO TO NEXT PAGE

Change 1

4-249