TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 571 of 933

TM 9-2520-270-34

47. INSPECT WIRE FABRIC (1).

a.

b.

c.

Inspect fabric (1) for dirt. If fabric

is plugged, clean it. See page 2-2.

Inspect fabric (1) for loose or bent

wires.

If fabric (1) is damaged, housing (2)

must be replaced. Go to step 55. If

fabric is not damaged, go to step 48.

49. CHECK MECHANICAL HOUSING (4).

a. Using micrometer caliper set,

measure outside diameter of

mechanical housing (4).

b. If measurement is less than

4.3288 inches (109.952 mm), go

to step 55. If not, go to step 50.

48. CHECK OUTPUT BEARING

SUPPORT (3).

a. Using micrometer caliper set,

measure outside diameter of bearing

support (3).

b. If measurement is less than

3.3443 inches (84.945 mm), go to

step 55. if not, go to step 49.

50. CHECK MECHANICAL HOUSING (5).

a. Using micrometer caliper set,

measure two outside diameters (6)

and one outside diameter (7) on

mechanical housing (5).

b. If either measurement (6) is less

than 2.9990 inches (76.175 mm), go to

step 55. If not, go to step 50c.

c. If measurement (7) is less than

3.3445 inches (84.950 mm), go to

step 55. If not, go to step 51.

4-246