TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 577 of 933

TM 9-2520-270-34

WARNING

Retaining ring is installed

under high tension. Use care

when removing and installing

retaining ring. Personnel can

be injured.

Always wear

goggles.

CAUTION

Beveled side of end plate must be installed

away from spur gear. End plate must be

installed by hand. Damage to equipment can

occur.

80. INSTALL BEARING (1) IF REMOVED.

a.

b.

Install bearing (1) and end plate (2) on

spur gear (3). Be sure end plate is

installed with bevel side up.

Using retaining ring pliers (Item 59),

install retaining ring (4) in groove (5).

81. INSTALL CLUTCH

4-252

Change 4

DISK (6) ON GEAR (7).

82. INSTALL NEW BEARING (8).

a.

b.

c.

If bearing (8) was removed, go to

step 82b. If not, go to step 83.

Using arbor press and bearing installer

(Item 10), press bearing (8) into gear

cluster (9).

Using retaining-ring pliers (Item 61),

install retaining ring (10).