TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 584 of 933

10. CHECK CLEARANCE (2) OF CLUTCH

DISK (3).

a. Measure clearance (2) between clutch

disk (3) and four brake pads (4).

b. If clearance (2) is 0.021-0.060 inch

(0.53-1.52 mm), go to step 14. If not, go

to step 11.

9. INSPECT SPINDLE ASSEMBLY (1).

a. Inspect spindle assembly (1). See

page 2-5.

b. Replace spindle assembly (1) if

damaged.

CAUTION

Do not pry against clutch disk. Damage to

equipment can occur.

11. REMOVE BRAKE (5).

a. Remove six self-locking bolts (6),

washers (7), and oil baffle (8). Discard

bolts.

b. Using pry bar, pry off brake (5).

12. REPAIR LEFT-HAND SINGLE

DISK BRAKE, page 4-262.

13. GO TO STEP 16.

GO TO NEXT PAGE

Change 3

4-257

TM 9-2520-270-34