TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 588 of 933

TM 9-2520-270-34

NOTE

Remaining steps will install hardware that will

prevent completion of an inspection tree.

33. IF YOU ARE RETURNING TO AN

INSPECTION TREE, GO TO END OF

TASK. IF NOT, GO TO STEP 34.

CAUTION

Do not force spindle assembly into brake

assembly. Metal seal ring can be damaged.

34. INSTALL SPINDLE ASSEMBLY (1).

a. Coat ring (2) with petrolatum.

b. Center ring (2) on spindle

assembly (1).

c. Insert spindle assembly (1) into

brake (3).

d. Aline screw holes in spindle plate (4)

with screw holes in brake (3).

35. SECURE SPINDLE ASSEMBLY (1).

a. Install two spacers (5) in two holes

in spindle plate (4).

b. Install two washers (6) and screws (7)

and tighten evenly.

36. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE TWO SCREWS (7)

TO 10-12 ft-lb (1-2 mkg).

37. INSTALL LEFT-HAND OUTPUT

HOUSING. See task REPLACE LEFT-

HAND OUTPUT HOUSING, page 4-314.

END OF TASK

4-261